Tuesday 4 June 2013

Backyard requirements to fit your Inflatable Birthday party jumping castle in: - Inflatable Birthday Party Jumping Castles

Make your child’s Birthday Party fun with a Jumping Castle by following these simple backyard tips.
So you are looking at renting an inflatable birthday party jumping castle for the kids party y in the backyard but not sure if you have the right requirements in your backyard to fit the jumping castle in. 
Below are typically the minimum needs you need to get the castle in and operating great:
1)      Have a gate opening of about 800mm for the installer to get the castle to its destination
2)      You need power within 25 metres.  If you have no power then you can rent a special blower
3)      Have grass to sit the castle on and you need 4m x 4m
4)      If you have concrete then around half a metre  extra space is needed so we can anchor with weights
5)      Do not have sand near the castle
6)      Do not allow face paint on the kids when they jump unless it is dry
7)      Read the rules we email you
8)      Have clear space above where the castle is going of between 3.2m and 4.2m depending on what you rent here in Canberra
9)      Space of land is not major so as long as a bucket of water can stand in the slope and
10)   Have a water source with hose nearby if you rent a water slide
Make your child’s Birthday Party fun with renting a kids castles from Jumping Castles Canberra. It is simple, fun and 4 hours of amazing exercise/ fun.




1 comment:

  1. Good Job! I enjoyed enough reading your latest article to read it again and again! It was so helpful. Waiting for your next entry.

    Jumping Castle Hire Brisbane

    ReplyDelete